Ricoh FT 4015 Service Manual page 103

20 December 1996
Mode No.
Auto Shut Off
Time Setting
14 (Energy Star)
Auto Reset
Time Setting
15 (Energy
Saver)
Count
16 Up/Down
Selection
Narrow Paper
Select Mode
17
Auto Feed
Station Shift
18
(Japanese
Market Only)
ADS Priority
19
SADF Shut Off
22
Time
Horizontal
Edge Margin
24
Width
Adjustment
Auto Sort
Select
28
Fusing
Temperature
29
Control
Selection
Selects the auto shut off time.
The copier main switch is shut off automatically after
the selected auto shut off time, if SP77 is at "0".
Selects an auto reset time of 1 or 3 minutes, or
cancels this mode.
The copier goes to energy saver mode
automatically after the selected auto reset time, if
SP78 is at "1".
Selects count up or count down.
Selects narrow paper feed mode for the by-pass
feed table.
Use this mode to feed non-standard paper sizes
that are too narrow to be detected by the by-pass
feed paper end sensor. In this case, the copier will
operate even if the Add Paper indicator is on.
Selects auto feed station shift mode.
The copier automatically shifts to the paper feed
station holding the same size of paper when paper
runs out.
Specifies whether the copier defaults to ADS or
Manual mode when the main switch is turned on.
Selects the shut off time for SADF mode.
The DF must be installed on the machine.
Selects whether the side erase mechanism changes
when the optional document feeder is installed.
See "Detailed Descriptions - Erase" for more details.
In Auto Sort Mode, the sorter is automatically
selected when more than 1 original is set on the DF
table and the entered copy quantity is greater than 1
and less than 11.
In Manual mode, sort mode has to be selected at
the operation panel.
The sorter and DF must be installed on the machine.
Selects the fusing temperature control mode.
After selecting the control mode and turning the
main switch off/on, the fusing temperature control
mode is changed.
Function
4-13
PROGRAM MODES
Settings
0: 30 min.
1: 15 min.
2: 60 min.
3: 90 min.
4: 120 min.
0: 1 min.
1: 3 min.
2: None
0: Up
1: Down
0: No
1: Yes
0: Auto Shift
1: Manual
0: ADS
1: Manual
0: 5 s.
1: 60 s.
0: DF Mode
1: Always stays
in Platen Mode
0: Manual
1: Auto Sort
0: ON/OFF
control
1: Phase
control