Ricoh FT 4015 Service Manual page 115

20 December 1996
4. Refer to the "SP MODE FACTORY SETTING DATA" sheet located
behind the operation guide sheet installed on the front cover, and enter
the data that were stored in the following SP modes at the factory.
•
SP41: Lead Edge Erase Margin
•
SP42: Registration Adjustment
•
SP43: Vertical Magnification Adjustment
•
SP44: Horizontal Magnification Adjustment
•
SP47: Focus Adjustment
•
SP48: Light Intensity Adjustment
5. Perform SP66 (TD Sensor Initial Setting).
NOTE: The machine will automatically stop when completed. (It takes
about 1 minute.)
6. Check the copy quality and the paper path and do any necessary
adjustment (see Replacement and Adjustment - Copy Quality
Adjustments).
4-25
PROGRAM MODES