Ricoh SWALLOW 2 Service Manual page 36

13 October 1997

25. Enter SP mode as follows:
1) Press the
2) Enter "107" using the numeric keys.
3) Hold down the
NOTE: When SP mode is selected, "1" blinks in the 3rd digit of the copy
counter, the Auto Image Density indicator starts blinking, and the
reduce/enlarge indicator turns off.
26. Perform the "TD sensor initial setting" SP mode as follows:
1) Enter "2" and press the

2) Enter "214" and press the
3) Press the
NOTE: The machine will automatically stop when TD sensor initial
setting is completed. (It takes about 2.5 minutes.)

Then perform the "Compulsory toner supply" SP mode as follows:
1) Press the
2) Enter "2" and press the

3) Enter "207" and press the
4) Press the
NOTE: The machine will automatically stop when compulsory toner
supply is completed. (It takes about 30 seconds.)
5) Compulsory toner supply must be performed twice in order to supply

enough toner to the toner hopper, so press the
27. Press the
key.

key for more than 3 seconds.


key.
key.

key twice.

key.
key.
key three times to exit SP mode.
key.
key.

33
INSTALLATION
A212I509.wmf
key again.