Connecting a serial cable between Brocade DCX-4S and host
FIGURE 5 Configuration tasks
Connecting a serial cable between Brocade DCX-4S and host
Follow these steps to connect a serial cable.
1. Verify that the Brocade DCX-4S is powered on and that POST is complete by ensuring that all
power LED indicators on the port, control processor, and core switch blades display a steady green
light.
2. Remove the shipping cap from the CONSOLE port on the active CP. Use the serial cable provided
with the Brocade DCX-4S to connect the CONSOLE port on the active CP to a computer
workstation. The active CP blade is indicated by an illuminated (blue) LED.
ATTENTION
The CONSOLE port is intended primarily for the initial setting of the IP address and for service
purposes.
34
Brocade DCX-4S Backbone Hardware Installation Guide
53-1001191-15