Brocade Communications Systems DCX-4S Backbone Hardware Installation Manual page 95

FIGURE 36 3-way ICL cable connections
1. Chassis 1
2. Core switch blades
3. Chassis 2
4. Chassis 3
5. ICL connector (ICL 1)
6. ICL connector (ICL 0)
NOTE
The same general configuration applies regardless of which backbone chassis are used. To keep all
three chassis in the same rack, any combination of DCX and DCX-4S backbones can be used
except three DCX chassis. A combination of three DCX chassis needs two adjacent racks.
NOTE
For clarity, the two "sets" of cables are drawn differently in
that one set is connected to only the blades in the "low order" slots (slot 3 in the DCX-4S and slot 5 in
Brocade DCX-4S Backbone Hardware Installation Guide
53-1001191-15
Removal and Replacement Procedures
Figure 34 through Figure 36 . Also note
95