Inspect The Shipment; Installation - STA-RITE Signature 2000 Owner's Manual

INSPECT THE SHIPMENT

The high pressure booster pump has been carefully
inspected and packaged to assure safe delivery.
Inspect the pump and fittings and report to the carrier
any items which are damaged or missing.
TABLE I - DISCHARGE PRESSURE
No. of
GPM HP Stages
7 1/2 9
7 3/4 12
7 1 16
10 1/2 6
10 3/4 8
10 1 10
10 1 11
10 1-1/2 14
10 2 16
20 1 7
20 1-1/2 9
20 2 11
20 3 15
30 1 5
30 1-1/2 6
30 2 7
30 3 11
*For total discharge pressure, add this pressure to suction pipe
pressure. For example, an HP7C pump taking suction from a 100
psi water service line will produce 130 + 100 = 230 psi total discharge
pressure at 0 GPM flow. If suction pressure drops to 50 psi,
discharge pressure will drop to 180 psi.
NOTE: Model numbers that include an "S" (HPS7C, HPS10D, etc)
have a stainless steel suction, discharge assembly, and capscrews.
Model numbers ending in "3" (HP7C3, HPS10C3, etc) have 3-phase
motors. Models numbers ending in "T" have TEFC motors.
Discharge Discharge
Pressure Pressure
PSI at PSI at
Rated Flow No Flow
90 130
123 173
162 229
74 113
97 147
134 188
146 202
173 206
197 260
75 110
97 143
123 175
195 250
59 75
71 91
81 106
129 167

INSTALLATION

The pump is designed to boost city water pressure or
water pressure from a private water system. Use this
high pressure stream to wash down milk parlors, barns,
garages and driveways, or for fire protection.
The pump is portable with a convenient carrying handle.
If an existing pressure water system is to be used as a
water supply, it can be connected with available fittings
and 3/4" or 1" high pressure hose to the pump inlet. A
special heavy duty 3/4" or 1" suction hose with fittings is
available as an accessory. If pump is permanently
mounted on wall, use a 3/4" or 1" pipe or heavy-duty
hose for suction line. 20 GPM models require one-inch
discharge hose to reduce friction losses and 30 GPM
models require 1-1/4".
Hazardous pressure. Pump body may
explode if pressures exceed rated limits. Maximum
inlet pressure is 80 PSI. Maximum discharge pressure is
315 PSI. Warranty is void if these pressure limits are
exceeded.
HIGH PRESSURE BOOSTER PUMP
INSTALLATION INSTRUCTIONS
These instructions cover high pressure booster pump
installations as shown below:
From pressurized
house service
Figure 1 – Connection to house service.
Figure 2 – Connection to water reservoir.
3
Suction
Discharge
Water tank
or reservoir
Suction
1208 0894
Discharge
1207 0894