Logging In To The Device - Fujitsu GW1500 Getting Started Manual

GW1500 Getting Started Guide
6. Click the [OK] button several times until the displayed dialog boxes are closed.
After setting the IP address for the setup computer, execute the ping command
and check the network connection.
Tips
The following shows an example of when the device IP address is
"192.168.1.1".
c:\>ping 192.168.1.1
Pinging 192.168.1.1 with 32 bytes of data:
Reply from 192.168.1.1: bytes=32 time=XXms TTL=127
Reply from 192.168.1.1: bytes=32 time=XXms TTL=127
Reply from 192.168.1.1: bytes=32 time=XXms TTL=127
Reply from 192.168.1.1: bytes=32 time=XXms TTL=127
Ping statistics for 192.168.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = XXms, Maximum = XXms, Average = Xms
c:\>
3.4

Logging in to the Device

Log in to the device using ssh (secure shell).
To log in using ssh, you need a separate ssh client software.
Attention!
- For this device, use an ssh client software that supports ssh protocol version 2.
- When you enter the password, ssh disconnects if there is no input for two
minutes.
- After you are logged in using ssh, ssh is disconnected if there is no input for 15
minutes (default value).
You can change the time from the login until the automatic logout using the
sshinfo autologout command.
[Operation Procedure]
1. Connect to the device using ssh.
The display may vary slightly depending on the ssh client software used. Specify the
device IP address as the target host. The default IP address of the device is
"192.168.1.1". The port number is fixed to "50022".
Specify "SSH2" for the ssh version.
37 Chapter 3 Device Settings