Device Base Surface - Fujitsu GW1500 Getting Started Manual

GW1500 Getting Started Guide
may be a device error. Please contact an engineer or an approved engineer of
our company.
1.1.5

Device Base Surface

Reset switch
- Reset switch (INIT)
- Reset switch (IP RESET)
- Rubber feet mount positions
- Importer's label
- Device nameplate
Importer's label
Device nameplate
Rubber feet mount positions
Press and hold (for approx. two seconds) to reset the
device to the factory default settings (initial status).
Press and hold (for approx. two seconds) to initialize
the device IP address.
Indicates the mount positions for the rubber feet
when the device is installed on a table top. Mount
them to the corners on the base surface of the device
(four locations).
A label that is required when you export the device to
Europe. It is usually not attached. If you need it,
contact your sales representative.
Contains information such as the device product ID,
production date, serial number, MAC address (ETH0
port), the Technical Regulations Conformity
Certification number, and the marks that you must
obtain for certification in each country in order to use
the device there.
17 Chapter 1 Overview