Fujitsu GW1500 Getting Started Manual page 27

GW1500 Getting Started Guide
Installing the device with its rear (ETH port side) facing towards the ceiling, or installing
the device on the ceiling as illustrated below is prohibited.
Attention!
- Attach the magnet sheet to the base surface of the device before installing it on
the wall.
- If a magnet sheet is used to install the device to a wall, be sure that the device
is not installed above a height of 500 mm from the floor.
- After installing it on the wall, confirm that it is firmly installed to prevent it from
falling.
- The magnet may not be strong enough depending on the conditions of the
installation surface.
- Because the magnet sheet's magnetic force may become weak over time,
check the strength periodically.
- Use one magnet sheet for one device.
- Do not put devices or media affected by magnetic forces near the magnet
sheet.
- The magnet sheet has a very strong magnetic force. When attaching it, be
careful not to get foreign materials or your fingers caught.
- Do not install it in a location where it may fall and hurt human body.
- Do not install it in a location with excessive vibrations or impacts, or an
unstable location. Doing so may drop components and cause injuries or
failures.
- Install cables firmly, so that the device does not fall due to the weight of the
cables. Not installing cables firmly enough may cause injuries or device failure.
- Fasten the cables so that the LAN cable, DC cord, or AC adapter cord do not
touch human bodies or chairs.
Magnet Sheet
Magnet Sheet
27 Chapter 2 Device Installation