Setting The Ip Address Of The Setup Computer - Fujitsu GW1500 Getting Started Manual

GW1500 Getting Started Guide
Maximum rated currents for circuit breaker: 3A
Be sure to use a circuit breaker that shuts down both poles at the same time.
- Be sure to select circuit breakers and shutdown devices that function
correctly with the device specifications in the list of "Power Supply
Conditions" in
4. Check that the device is powered on.
Shortly after the power is turned on, the STATUS lamp on top of the device blinks green,
which indicates that the device is starting up. When the device starts up normally, the
STATUS lamp lights up green.
If the STATUS lamp lights up red, there is a failure in the device.
For the meanings of each lamp, refer to
3.3 Setting the IP Address of the
Setup Computer
Set the IP address of the setup computer.
The following is an example using Windows 7.
[Operation Procedure]
1. Open [Control Panel].
2. Select [Network and Internet] > [Network and Sharing Center] > [Local Area
Connection].
The [Local Area Connection Status] dialog box is displayed.
3. Click the [Properties] button.
The [Local Area Connection Properties] dialog box is displayed.
4. Select [Internet Protocol Version 4 (TCP/IPv4)], and then click the [Properties]
button.
"2.1.1 Checking the Installation Conditions" on page
"1.1.4 Device Top View and Lamps" on page
35
19.
15.
Chapter 3 Device Settings