Table of Contents
Advertisement
Quick Links
ENGLISH
Manufacturer : FAAC S.p.A.
Address:
Via Benini, 1
40069 - Zola Predosa
BOLOGNA-ITALY
Declares that: Electronic control unit 844 T
•conforms to the essential safety requirements of the following directives:
73/23/EEC and subsequent amendment 93/68/EEC.
89/336/EEC and subsequent amendment 92/31/EEC and 93/68/EEC
Additional information:
This product underwent a test in a typical, uniform configuration (all products
manufactured by FAAC S.p.A.).
Bologna, 01 January 1997
CE DECLARATION OF CONFORMITY
The Managing
Director
A. Bassi
7
ENGLISH
Advertisement
Table of Contents
Related Manuals for FAAC 844 T
Summary of Contents for FAAC 844 T
- Page 1 Address: Via Benini, 1 40069 - Zola Predosa BOLOGNA-ITALY Declares that: Electronic control unit 844 T •conforms to the essential safety requirements of the following directives: 73/23/EEC and subsequent amendment 93/68/EEC. 89/336/EEC and subsequent amendment 92/31/EEC and 93/68/EEC Additional information: This product underwent a test in a typical, uniform configuration (all products manufactured by FAAC S.p.A.).
- Page 2 17) Use of at least one indicator-light is essential for each system (e.g.: FAAC LAMP MINILAMP, etc.) as well as a sign adequately fixed to the frame structure, in addition to the devices mentioned at point “16”.
- Page 3 (long for mod. E, short for models L and LM) in the 3 S-holes (Fig.2). 1. TECHNICAL SPECIFICATIONS TABLE 1 TECHNICAL SPECIFICATIONS OF 844 T CONTROL UNIT Power supply 230V 3ph (+6 -10 %) 50Hz 400V 3ph+N (+6 -10 %) 50Hz...
- Page 4 DECODER, RP RECEIVERS (Fig. 3, 4, 5) contact between terminals 8 and 9 (see fig. 6). Install by fitting the accessory cards so that their components side faces the inside of the 844 T electronic appliance. Insert and remove the cards after cutting power. INTERRUPTED LK1...
- Page 5 ENGLISH ENGLISH 4. PROGRAMMING TABLE 6 LOGIC S1 (SAFETY) To program operation of automation, use the microswitches as PULSES LOGIC S1 shown below. GATE STATUS OPEN A - OPEN B (1) STOP SAFETY DEVICES CLOSED opens and closes no effect no effect after pause time (2) Logic...
- Page 6 Normal operation can be restored only after eliminating the 8. ELECTRICAL CONNECTIONS WITH 230V 3ph alarm cause and pressing the RESET push-button (or turning off To connect the 844 T appliance to a 3-phase 230 V mains, power supply momentarily). observe the diagram in F ig.8.
Need help?
Do you have a question about the 844 T and is the answer not in the manual?
Questions and answers