Advertisement
Safety Precautions
1. Please open the package to check if it is damaged due to transportation after receiving the light. In the case of damage caused by transportation, please do not use this light and contact the
dealer or manufacturer as soon as possible.
2. Do not use a power cord with damaged insulation. Do not unplug hard or drag the power cord directly.
3. Make sure that the power supply voltage used matches the voltage specified by the light before installation.
4. When not using or cleaning the light, please turn it off.
5. Keep the light safely stored and away from children.
Notice
1. When the panel is on don't look direct at the emitter.
2. Don't place objects on the light emitter or allow liquid to flow inside the fixture or the emitter.
3. Don't place fixture near flammable substances like alcohol or gasoline.
4. When cleaning the fixture, please wipe off debris or dirt using a cloth and only dampen with water or a lighti cleanser.
5. The MixPanel 60 / 150 should be safely operated where it won't be at risk of getting wet or under extreme temperatures. Please make sure the ventilation fan is not blocked or obstructed.
6. Do not repair the MixPanel 60 / 150 by yourself. Professionals, please adhere to the user manual while troubleshooting.
7. For optimal cooling of the fixture, the vents should not be covered when using, or will damage the equipment. When using the lighting for a long time, the temperature of the lighting is high,
please pay attention to anti-scalding.
Genaral Fault Detection and Diagnosis
Fault Detection
The light won't boot up properly!
The fixture can operate by manual,
but DMX control is not working.
LCD display is on but can't operate the light.
The inside fan will not work.
1. Please see if there are any loose connections between the adapter, power cord or power port on fixture.
2. Please check if the adapter voltage is within specified parameters.
3. If an external battery is used, please check if the battery is connected properly. Please check if battery voltage is
within the specified voltage.
1. Please check whether the DMX original adress setting of the fixture is correct or not.
2. Check that the XLR signal cable is connected correctly or is damaged.
Please check if the LCD screen display " LOCK ", long press the " LOCK " key for 2 seconds to release the LOCK.
1. Please check if the fan is set to the off status manually.
2. When the LCD screen display "
Diagnosis
" in the right top corner , please check if the internal fan work normally.
27
Advertisement
