Epson Stylus COLOR 900 Service Manual page 163

EPSON Stylus COLOR 900/900N
Table 6-3. Lubrication Points (continued)
No. Lubrication Point
The shafts on which the gears are
mounted in the Pump Unit
15
• Avoid getting grease between the
CR lock mechanism and the gear
that turns it.
The plastic part of the Wiper Blade
where it slides against the frame of
the Pump Unit.
16
• Avoid getting grease on the rubber
or felt part of the blade itself.
The ASF drive shaft hole in the right
side of the ASF frame
17
• Use a brush to apply the grease
evenly to the entire inside surface
of the hole.
The right and left Hopper Release
Latches in the ASF unit
18
• Use a brush to apply the grease
evenly.
Lubricant
Amount Ref. figure
Type
×
G-26 1 1 mm —
Apply a small
amount to the
G-26 —
friction
surfaces.
×
G-26 1 1 mm Figure 6-6
×
Figure 6-7
G-26 1 2 mm
C R G u i d e R a i l
( b e t w e e n a r r o w s )
Figure 6-1. Carriage Guide Rail Lubrication
P u l l e y T e n s i o n i n g
M e c h a n i s m
Figure 6-2. Pulley Tensioning Mechanism Lubrication
Chapter 6 Maintenance
160