Epson Stylus COLOR 900 Service Manual page 108

EPSON Stylus COLOR 900/900N
8. Disengage the hopper assembly from the two pins on which it's
hinged at the top of the ASF frame, as shown below.
Figure 4-27. Hopper Assembly Removal
9. Free the hopper latch located on the right side of the hopper
assembly by passing it inward through the hole in the side of the
ASF frame. (This is made easier if you compress the spring behind
the right roller assembly while freeing the latch.) Then remove the
hopper assembly together with the left and right feed rollers.
C H E C K
After assembling the ASF unit, try pulling the detection
P O I N T
wheel off the shaft. If it's loose, press it on more
securely.
Chapter 4 Disassembly and Assembly
4.2.8.7 Disassembling the Feed Rollers
1. Disassemble the ASF unit. (See
2. Take out the compression springs from the back of each roller
assembly.
3. Release the hook securing the roller cover to the roller assembly,
and then remove the roller cover.
Figure 4-28. Feed Roller Cover Removal
page 103.)
Hook
105