Interface Connectors; 10Base2; 10Baset; Aui - Xycom XVME-976 Manual

Adapter module

Hide thumbs Also See for XVME-976:

Table of Contents

XVME-976 Adapter Module

Interface Connectors

The paragraphs below describe connectors 10BASE2, 10BASET, and AUI.

When the BNC connector is used, a BNC TEE must be connected to the XVME-

956/411's BNC connector if the Ethernet coax does not end at the XVME-956/411.

If the coax ends at the XVME-956/411, a 50 Ohm terminator must be installed. This

terminator can be a BNC terminator if the BNC TEE is used or the internal XVME-

956/411 termination option can be used.

When twisted pair networks are used, a 10BaseT hub must be supplied. You cannot

simply connect from one interface card to another when twisted pair is used.

This connector is provided to external transceivers. This connector is a female D-

SUB connector with a pinout that matches the AUI standard pinout. 12 V power on

the AUI connector is directly connected to the PC/104 bus 12 V system power.

5-10

Table of Contents

Do you have a question about the XVME-976 and is the answer not in the manual?