5.3.2 Remark
The remark for each channel.
5.3.3 Changing attribute
It has two attribute for dimming: Break and Gradual change.
Break: when dimming this channel, the brightness will change jumpingly.
Gradual change: when dimming this channel, the brightness will change gradually.
5.3.4 Load test
Before an end-user panel is configured, this window can be used to trigger the
Dimmer/Relay, so as to check the wiring. As above screen shot show, if "Start test" is
clicked, the channel 1 of device 1-3 will start to flash (the Interval is set as 2s). After
confirmation, click "Stop test" and then "Turn off load".
DMX Controller – User Manual
User Manual
SB-DN-512DMX
9