Smith & Noble Deco Metal Hardware Step By Step Installation Instructions
Ceiling mount single rod set
Hide thumbs
Also See for Deco Metal Hardware:
- Step by step installation instructions (9 pages) ,
- Step by step installation instructions (7 pages)
Subscribe to Our Youtube Channel
Related Manuals for Smith & Noble Deco Metal Hardware
Summary of Contents for Smith & Noble Deco Metal Hardware
- Page 1 STEP BY STEP INSTALLATION INSTRUCTIONS Deco Metal Hardware Ceiling Mount Single Rod Set...
-
Page 2: Table Of Contents
Everything Table of Contents You Need Getting Started ........3 Step 1 - Overview - Ceiling Mount Single Rod Set . -
Page 3: Step 1 - Getting Started
STEP 1 - GETTING STARTED OVERVIEW Parts & Tools Deco Metal Ceiling Mount Single Rod Set Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough to MOUNTING FINIAL BRACKET... -
Page 4: Step 2 - Marking Bracket Placement
STEP 2 - MARKING BRACKET PLACEMENT STEP 2 - MARKING BRACKET PLACEMENT STEP 1: Remove mounting plate and center it FIGURE A inside of the circle outline on wall. Mark Place bracket level against ceiling at FIGURE B Mark all holes needed the screw hole locations for all brackets the marked spots. -
Page 5: Step 3 - Attaching The Rod Connector
STEP 3 - ATTACHING THE ROD CONNECTOR STEP 4 - ADDING OR REMOVING CARRIERS Depending on your order, you may Adding or Removing have received a rod connector. Carriers to the Rod CARRIERS CONNECTOR Your track rod will come with all master A rod connector is the short piece of carriers and regular carriers pre- metal placed inside each end of the... -
Page 6: Step 5 - Attaching Finials
STEP 5 - ATTACHING FINIALS STEP 6 - ATTACHING THE ROD TO BRACKET FIGURE A Attach Bracket Posts to Attach finials by tightening the set OUTSIDE screw. Rod (Track) POST Slide outside posts onto rod (see SCREW Figure A). SCREW Align outside posts with Inside Posts. -
Page 7: Step 7 - Attaching Drapery To Rod
STEP 7 - ATTACHING DRAPERY TO ROD ACCESSORIES Baton/Wand (optional) Insert drapery pin hooks into carriers CLIP and master carriers. Baton/Wand will be pre-attached to Split Drapery the master carrier(s). SPLIT DRAPERY For Split drapery, start pinning from the center and go towards the ends. MASTER BATON/ CARRIER... -
Page 8: Care & Cleaning
CARE & CLEANING NOTES Minimal care and cleaning is needed to maintain the beauty of your Hardware. To Vacuum: Use brush or dust head attachment. To Dust: Use soft, clean cloth. smithandnoble.com 800.248.8888... -
Page 9: Warranty
Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship. Hardware must have been properly installed.
Need help?
Do you have a question about the Deco Metal Hardware and is the answer not in the manual?
Questions and answers