Table of Contents
Advertisement
Internal Modem Guide
This appendix describes how to install and the remove the internal modem.
CAUTION: Do not disassemble the computer beyond the steps described
in this instruction or touch any components not specifically described.
Installing the internal modem
NOTE: The internal modem is preinstalled. The following is for informa-
tion only.
CAUTION: Refer to General Precations for the attention when keybord
brace is removed.
To install the internal modem follow the procedures below.
Installing the modem board and jack
To install the modem board and jack, follow the steps below.
1. Save your data and turn off the computer.
2. Disconnect the AC adaptor and other peripheral devices.
3. Turn the computer upside down and remove the battery pack.
4. Slide the display latch on the front of the computer to the right and open the
display panel.
5. Insert your fingernail or a thin object under the rim of the keyboard brace and
lift out the brace.
6. Remove two screws securing the keyboard and one screw securing the metal
brace. Lift off the metal brace.
7. Lift up the back of the keyboard, rotate it toward you and lay in face down on
the palm rest.
8. Lift into the left the insulation sheet covering the modem board and secure the
sheet with tape to keep it out of your way.
Appendix F
F-1
Advertisement
Table of Contents
