Toshiba A40 Series User Manual page 238

User's Manual
T Select tone dialing
This command instructs the modem to send DTMF tones while dialing.
Dialed digits are tone dialed until a P command or dial modifier is
received. This is the default setting.
Vn DCE response format
This command controls whether result codes (including call progress
and negotiation progress messages) are displayed as words or their
numeric equivalents.
V0
Displays result codes as digits.
V1 Displays result codes as text (default).
Result Codes:
n=0,1
OK
ERROR Otherwise
Xn Result code selection, call progress monitoring
This command selects which result codes will be used by the modem.
Command Dial tone
detect
X0 Disable
X1 Disable
X2 Enable
X3 Disable
X4 (default) Enable
C-6
Busy signal Supported Result
detect Code
Disable OK, CONNECT, RING, NO CARRIER,
ERROR
Disable OK, RING, NO CARRIER, ERROR,
CONNECT <RATE>
Disable OK, RING, NO CARRIER, ERROR,
NODIALTONE, CONNECT <RATE>
Enable OK, RING, NO CARRIER, ERROR,
BUSY, CONNECT <RATE>,
BLACKLISTED
Enable OK, RING, NO CARRIER, ERROR,
NODIALTONE, BUSY, CONNECT
<RATE>, DELAYED, BLACKLISTED,
REORDER, WARBLE, CALL WAITING
DETECTED