Removing The Inner Glass To Access The Fire Bed - Stanley ARGON F650 Installation, Servicing And User Operating Instructions

GB & IE version
3.4.3 Removing the Inner Glass and Seal to Access the Firebox
Instructions on how to Remove and Refit the Inner Glass
To access the fire box you need to open the cast door using the handle
Then you will see a steel frame with 6 x M5 flange screws in it, this holds on the piece of ceramic glass
which actually forms the seal of the gas firebox. Remove the 6 x M5 flange screws and take off the outer
metal frame, the glass then sits in two small lugs at the bottom, lift the glass up gently out of the 2 x
holding lugs
Please note the glass has a heatproof fibre gasket fitted all of the way round it on both sides please
make sure this is not damaged in anyway
Once the glass has been removed you can then lay the ceramic embers and logs as per the instructions
Re-fit the glass in the reverse sequence but making sure the 6 x M5 flange screws are not over
tightened otherwise you will crack the glass when it get hot, they just need to be hand tight to form an
airtight seal
Please make sure any fingerprints are wiped off the inside and the outside of the glass otherwise they
will mark the glass permanently
When the stove is first lit the glass will form condensation on the inside and that will clear after about two
minutes
25