Table of Contents
Advertisement
3.6 Fitting Batteries into the Battery Box & Connecting to the Stove
Item 1
Item 2
Item 3
Item 4
Connecting the Battery Box
Item 1 - Take out the small Philips screw and slide
the lid off
Item 2 - Place in the 4 x AA batteries supplied
please note only use Duracell Alkaline batteries -
Do not use rechargeable batteries
Item 3 - The Male jack plug on the end of the
battery pack will now plug into the female socket
which is in the bottom of the battery pocket at the
rear of the stove
Please ensure the battery box is turned to the ON
position with the slider switch at the top. When in
the ON position you will hear the controller beep
once
Item 4 – Place the battery pack back into the
holder at the rear of the stove
When the battery box is fitted please do not put
batteries into the receiver which is in a
heatproof silver pocket under the stove as this
will cause permanent damage to the receiver
and void your warranty
The battery box is easily removed, and is on a 500
mill long extension cable but when you need to
change the batteries on an annual basis just lift the
battery box out, disconnect the battery box using
the male and female jack plug socket and then
change the internal 4 x AA batteries replace the
screw and lid correctly and reconnect
GB & IE version
35
Advertisement
Table of Contents
