Hints And Tips - AEG BY931460KM User Manual

20 www.aeg.com
If the Pyrolysis function
operates, the door is locked
and the symbol of a key
comes on in the display.
To deactivate the function, press
display shows a message. Press
and then
When you deactivate the
appliance, the function also
deactivates.
10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it
later with one press of any symbol.
1. Activate the appliance.
2. Set a heating function.
3. Press
display shows: Duration.
4. Set the time.
5. Press
display shows: Set + Go.
6. Press
Press any symbol (except for
the function: Set + Go. The set heating
function starts.
When the heating function ends, an
acoustic signal sounds.
• Function Lock is on when
• The menu: Basic Settings
10.5 Automatic Switch-off
For safety reasons the appliance turns off
automatically after some time if a heating

11. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
to confirm.
again and again until the
again and again until the
to confirm.
the heating function
operates.
lets you activate and
deactivate the function:
Set + Go.
function operates and you do not
change any settings.
Temperature (°C)
30 - 115
. The
120 - 195
again
200 - 245
250 - maximum
10.6 Brightness of the display
There are two modes of display
brightness:
• Night brightness - when the appliance
is deactivated, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the appliance is activated.
– if you touch a symbol during the
) to start
– if the appliance is deactivated and
10.7 Cooling fan
When the appliance operates, the
cooling fan activates automatically to
keep the surfaces of the appliance cool.
If you deactivate the appliance, the
cooling fan can continue to operate until
the appliance cools down.
Switch-off time (h)
12.5
8.5
5.5
1.5
The Automatic switch-off
does not work with the
functions: Light, Food
Sensor, Duration, End Time.
night brightness (apart from ON /
OFF), the display goes back to
the day brightness mode for the
next 10 seconds.
you set the function: Minute
Minder. When the function ends,
the display goes back to the night
brightness.