Table of Contents
Advertisement
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
2
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must
point to the front.
12.3 Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
The pyrolytic cleaning
procedure cannot start:
• if you did not remove the core
temperature sensor plug from the
socket.
• if you did not fully close the oven
door.
Remove the worst dirt manually.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them at
the same time as the
function: Pyrolysis. It can
cause damage to the
appliance.
1. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
2. Turn on the appliance and select
from the main menu the function:
Pyrolysis. Press
3. Set the duration of the cleaning
procedure:
Option
Quick
Normal
Intense
4. Press
to confirm.
When the pyrolytic cleaning
starts, the appliance door is
locked and the lamp does
not work.
To stop the pyrolytic
cleaning before it is
completed, turn off the
appliance.
WARNING!
After the function is
completed, the appliance is
very hot. Let it cool down.
There is a risk of burns.
After the function is
completed, the door stays
locked for the cool down
phase. Some of the
appliance functions are not
available during the cool
down phase.
12.4 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
ENGLISH
41
to confirm.
Description
1 h for a low
degree of dirt
1 h 30 min for
a usual de-
gree of dirt
2 h 30 min for
a high degree
of dirt
Advertisement
Table of Contents
