Toshiba TECRA A2 User Manual page 198

AT Commands
Dial tone detect
Disabled:The modem dials a call regardless of whether it detects a dial
Enabled:The modem dials only upon detection of a dial tone, and
Busy tone detect
Disabled:The modem ignores any busy tones it receives.
Enabled:The modem monitors for busy tones.
Zn Recall stored profile
The modem performs a soft reset and restores (recalls) the configuration
profile according to the parameter supplied. If no parameter is specified,
zero is assumed. Either Z0 or Z1 restores the profile.
&Cn Data Carrier Detect (DCD) control
Data Carrier Detect is a signal from the modem to the computer indicating
that a carrier signal is being received from a remote modem. DCD normally
turns off when the modem no longer detects the carrier signal.
&Dn DTR control
This command interprets how the modem responds to the state of the DTR
signal and changes to the DTR signal.
C-6
tone.
disconnects the call if the dial tone is not detected within 10
seconds.
Result Codes:
n=0,1,2,3,4,5
OK
ERROR Otherwise
Result Codes:
n=0,1
OK
ERROR Otherwise
&C0 The state of the carrier from the remote modem is ignored.
DCD circuit is always on.
&C1 DCD turns on when the remote modem's carrier signal is
detected, and off when the carrier signal is not detected
(default).
Result Codes:
n=0,1
OK
ERROR Otherwise
&D0 Ignore. The modem ignores the true status of DTR and treats
it as always on. This should only be used if your
communication software does not provide DTR to the
modem
&D1 If the DTR signal is not detected while in on-line data mode,
the modem enters command mode, issues an OK result
code, and remains connected.
User's Manual