TECRA A2
HW Setup and Passwords
This chapter explains how to use TOSHIBA HW Setup program to
configure your computer and how to set passwords.
HW Setup
TOSHIBA HW Setup lets you configure settings for General, Password,
Parallel/Printer, Device Config, Display, CPU, Boot Priority, Keyboard, LAN
and USB.
If the supervisor password is set, access to the TOSHIBA HW Setup
program can be prevented when the user password is used to log on to the
computer. Some models are not equipped with Parallel/Printer tab and/or
CPU tab.
Accessing HW Setup
To run HW Setup, click start, click Control Panel, click Printers and
Other Hardware and select TOSHIBA HW Setup.
HW Setup window
The HW Setup window contains the following tabs: General, Password,
Parallel/Printer, Device Config, Display, CPU, Boot Priority, Keyboard, LAN
and USB.
There are also three buttons: OK, Cancel and Apply.
OK
Cancel
Apply
User's Manual
Chapter 7
Accepts your changes and closes the HW Setup
window.
Closes the window without accepting your
changes.
Accepts all your changes without closing the HW
Setup window.
7-1