Self Test; Power - Toshiba TECRA A2 User Manual

Troubleshooting

Self test

When the computer starts up, the self test will be run automatically, and the
following will be displayed:
S
This message remains on the screen for a few seconds.
If the self test is successful, the computer tries to load the operating
system, depending on how the Boot Priority is set in the TOSHIBA HW
Setup program.
If any of the following conditions are present, the self test failed:
The computer stops and does not proceed to display information or
messages except the TOSHIBA logo.
Random characters appear on the screen, and the system does not
function normally.
The screen displays an error message.
Turn off the computer and check all cable connections. If the test fails
again, contact your dealer.

Power

When the computer is not plugged into an AC outlet, the battery pack is the
primary power source. However, your computer has a number of other
power resources, including intelligent power supply, Real Time Clock
battery. These resources are interrelated and any one could affect
apparent power problems. This section provides checklists for AC power
and the battery. If you cannot resolve a problem after following them, the
cause could lie with another power resource. In such case, contact your
dealer.
Overheating power down
If the computer's internal temperature becomes too high, the computer will
automatically enter Hibernation or Resume mode and shut down.
Problem
Computer shuts down
and DC IN 15V
indicator blinks orange
It is recommended to leave the computer off until the its interior reaches
room temperature even though the DC IN 15V indicator stops blinking.
9-4
In Touch with Tomorrow
TOSHIBA
Procedure
Leave the computer off until the DC IN 15V
indicator stops blinking.
If the computer has reached room temperature
and still does not start, or if it starts but shuts
down quickly contact your dealer.
User's Manual