Table of Contents
Advertisement
KPM(T) Series Flat Panel Industrial Monitor
A full-stroke keyboard is needed to enter keystrokes while recording a new key
macro, editing an existing macro, or entering utility commands. You can redefine all
keys on the keypads, except the F/A (Function/Alpha) key. While the utility is
running, the keypads are disabled.
Dialog boxes appear for user prompts, and to display error and user advice messages.
Any keys used specifically in each menu are shown at the bottom of each screen (see
Figure 5-1).
Two keys allow you to exit the menus:
•
ESC
F1
•
be chosen to exit this menu
Startup
To begin using the keypad utility, type kp3util at the prompt (for the floppy drive
when no DOS is available, or the subdirectory you created earlier). The program will
bring up the main menu. Open the def3612.pkm file in the main menu to program the
keypad. (This file contains the default keypad settings for the KPM(T) monitors.)
Changes to the default file should be saved to a new file with the pkm extension. If
you do not open a file, the macros pull-down menu will not be available.
If you make any changes to your keypad and want to set it back to the default settings,
open the pkm file for your unit (e.g., def3612.PKM for 5015KPM) from the File/Open
menu, and then download it from the download menu.
Main Menu
Figure 5-1 shows the Main Menu screen. The functions of the pull-down menus are
described in the following sections.
Exit and Download do not have pull-down menus.
Use
F
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
moves to the previous menu or out of the utility from the Main Menu
returns to the current menu headings in some of the menus where
Do not save any changes to the default files.
1 to access the menu bar options in the kp3util program.
39
Chapter 5 – Keypad Utility Program
Note
Caution
Note
Note
can
Exit
143448 (D)
Advertisement
Table of Contents
