Table of Contents
Advertisement
KPM(T) Series Flat Panel Industrial Monitor
Quick Startup
This section gives you the steps to get the system up and running without explaining
the capabilities and options.
Remove power from the unit and disconnect the power cord before making
any adjustments to the inside or outside of the monitor.
For Hazardous Locations installation, review Hazardous Locations
Installation in Chapter 2 before startup.
To prepare the system for use, perform the following steps.
1. Attach optional keyboard to the keyboard port.
2. Attach optional mouse to the mouse port.
3. Attach other optional equipment following the instructions in Chapter 2.
4. Attach the power cord from the power receptacle to a properly grounded 100-240
VAC, 50-60 Hz, or an optional 18-30 VDC power source. (See System Power in
Chapter 2 for more information.)
5. Turn on power to the KPM(T) monitor (via an outlet power switch if applicable).
Then turn on power to the host computer. The system will boot up into the
operating system.
6. If the unit is equipped with a touch screen, install drivers on the host computer
via the floppy, the CD-ROM, or the network, as applicable.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Warning
Warning
8
Chapter 1 – Introduction
143448 (D)
Advertisement
Table of Contents
