Table of Contents
Advertisement
KPM(T) Series Flat Panel Industrial Monitor
Special functions, such as Capslock and Numlock, cannot be part of a
• • • •
programmed keypad macro sequence.
Hot unplug of a full-travel keyboard or mouse from the KPM(T) monitor is
• • • •
not supported.
Using the Pro-face/Xycom models 33XX/34XX as a host is not supported.
• • • •
Maximum total USB cable length between the host and the USB device cannot exceed
5M. Example: 3M USB cable from the host computer to the KPM(T) monitor and a 2M
USB cable from the front of the KPM(T) monitor to the USB device.
XVME Compatibility Issues
Listed below are XVME compatibility issues that apply to the 5012KPM(T) and
5015KPM(T):
If you are going to connect a KPM(T) monitor to a Pro-face/Xycom XVME-660
• • • •
or XVME-661 processor board, the CPU module must have BIOS revision 1.3
(or higher). The Pro-face/Xycom BIOS revision number will appear at the top
of the screen briefly during system boot-up. If you do not see the Pro-face/Xycom
BIOS revision number for the CPU module, enable the Boot Time Diagnostic
Screen in the Advanced menu of the BIOS setup (see the XVME-660 or
XVME-661 manual for more details). Older Pro-face/Xycom processor boards
(i.e. XVME-654, XVME-655, and older) have not been validated to work with
the 5012KPM(T) or the 5015KPM(T).
Using the XVME-653, 656, 658 or 659 as a host is not supported.
• • • •
To get a copy of the new BIOS revision, call Pro-face technical support at
734-944-0482, or email
Using a Touch Screen
Pro-face/Xycom's touch screen complies with environmental specifications and
maintains a NEMA 4 seal when panel mounted. The touch screen controller emulates
a Microsoft PS/2 mouse. For more information about your touch screen, see Chapter
4, Operator Input.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Note
support@profaceamerica.com
16
Chapter 2 – Installation
143448 (D)
Advertisement
Table of Contents
