Mira GO 8.5 Installation, Operation, Maintenance Manual page 26

2. Mira Go
Read the section "Important Safety Information" first.
Many household cleaners contain abrasives and chemical substances, and should not
be used for cleaning plated or plastic fittings. These finishes should be cleaned with
a mild washing up detergent or soap solution, and then wiped dry using a soft cloth.
THE SPRAY PLATE HOLES MUST BE KEPT CLEAR. The spray plate should be
regularly removed and cleaned. Depending on the hardness of the water to the shower
this should be carried out at least once a month. Lack of regular spray plate cleaning
will lead to poor performance and cause early failure of the Mira Go. Refer to the
Installation, Operation and Maintenance guide for the fittings.
2.1. Switch on pull-cord or wall mounted switch.
2.2. Press the START button.
2.3. Rotate the TOP control knob to the high position (Full Power).
2.4. Wait 15-20 seconds for warm water to reach the handset.
2.5. If necessary turn the BOTTOM control knob slowly to adjust temperature.
Allow 10-15 seconds for the adjusted temperature to reach the handset. The
control knob operates through approximately ¾ of a turn from cold to hot.
Clockwise rotation will give warmer water with less flow. Anticlockwise
rotation will give cooler water with more flow.
2.6. TO TURN OFF the Mira Go press the STOP button. The appliance will
continue to run for a few seconds before stopping.
2.7. A small amount of water may be retained in the shower handset after the
shower control has been turned off. This may drain over a few minutes.
For summer economy showering use position 'MEDIUM' (Half Power) on the
control. For a cold shower select 'LOW'.
2.8. Switch off pull-cord or wall mounted switch.
26