Mira GO 8.5 Installation, Operation, Maintenance Manual page 15

1.10. Drill and plug the top two fixing holes. Secure the Mira Go to the wall with the
screws provided. Drill the bottom fixing hole with the product in place.
Alternative fixings (not supplied) may be necessary for some wall structures.
Avoid drilling into any supply cable/pipe.
1.11. Install the mains-fed cold water supply pipe.
Terminal Block
Cold Water
Top Entry
Electrical Supply
Cable
Electrical
Rear Entry
Inlet Connector
Assembly
(The inlet
connector
assembly can be
swivelled to suit the
supply)
Cold Water
Supply Pipe
Bottom Entry
Installation of the Mira Go
Holes For Cover
Retaining Screws
Fixing Screw
Splash Guard
(Make sure that it is
secured before operating
the shower).
Do not fit the Mira Go to the
wall and tile up to the case.
The Mira Go must be fitted
on to a finished flat and
even wall surface (small
pillars moulded on to the
back of the case allow air
circulation).
Service Tunnel
(The service tunnel
or case may be
trimmed to suit
rising or falling
supply)
Cover Retaining
Screw
15