Mira GO 8.5 Installation, Operation, Maintenance Manual page 22

4.15. Refit the components in reverse order. Make sure that the electrical wires are
installed in the correct positions.
15mm
compression
straight connector
(not supplied)
Inlet Connector
5. Thermal Switch - Removal and Installation
Warning! Make sure that the electrical supply is turned off at the mains and the
appropriate circuit fuse is removed. Mains electrical connections are exposed when the
cover is removed.
5.1. Remove the three cover retaining screws, the cover and the service tunnel.
5.2. Remove the hose from the outlet connector and loosen the connection to the inlet
connector assembly.
5.3. To improve access to the top terminals of the tank the terminal block may be
loosened by removing the fixing screw.
22
Switch
Assembly
Clamp Bracket
Clamp
Retaining Screws
Bracket
Heater Tank - Removal and Installation
Flow Valve
Solenoid Valve
Thermal Switch
Heater Tank
Heater Tank
Retaining Screws
Outlet Connector