Page 1
HD 6/12-4 C HD 6/12-4 CX Deutsch English HD 6/15 C HD 6/15 CX Français HD 7/18 C HD 7/18 CX Italiano HD 7/10 CXF Nederlands Español Português Dansk Norsk Svenska Suomi Ελληνικά Türkçe Русский Magyar Čeština Slovenščina Polski Româneşte Slovenčina...
Please read and comply with 22 Safety lever these original instructions prior 23 High pressure hose EASY!Lock to the initial operation of your appliance and 24 Push handle store them for later use or subsequent own- 25 Cable clamp ers. 26 Clamping screw for pushing handle 27 Detergent suction hose with filter Contents...
Total hardness < 28 °dH Symbols on the machine < 50 °TH < 500 ppm High-pressure jets can be dan- (mg CaCO gerous if improperly used. The Iron < 0,5 mg/l jet may not be directed at persons, animals, Manganese <...
Old appliances contain valuable materials that can be recycled; these should be sent for recy- cling. Batteries, oil, and similar substances must not enter the environment. Please dispose of your old appliances using appro- priate collection systems. Electrical and electronic devices often con- tain components which could potentially pose a danger to human health and the en- Mount the nozzle on the spray lance...
For connection values refer to technical Start up specifications. WARNING Connect the supply hose (min. length Risk of injury! Appliance, accessories, sup- 7.5 m, minimum diameter 1/2“) to the ply lines and connections must be in fault- water connection point of the machine free condition.
Page 8
Kärcher detergents ensure smooth func- Opening/closing the trigger gun tioning. Please consult us or ask for our cat- To open the trigger gun: Actuate the alogue or our detergent information sheets. safety lever and trigger. Take out detergent suck hose. To close the hand spray gun: Release Suspend end of suction hose in a con- the safety lever and trigger.
Storage Storing the Appliance Insert the hand-spray gun in the holder. CAUTION Wind up the high-pressure hose and Risk of personal injury or damage! Consid- hang it over the hose storage. er the weight of the appliance when storing Wind up the high-pressure hose on the Care and maintenance hose drum.
Clean the sieve in the water connection. Every 500 operating hours, at least Check all inlet pipes to the pump. annually Contact Customer Service if needed. Have the maintenance of the device Pump leaky performed by the customer service. Oil change. 3 drops per minute are permitted and can come out from the lower side of the appli- Oil change...
Page 11
EU Declaration of Conformity We hereby declare that the machine de- scribed below complies with the relevant Chairman of the Board of Management Director Regulatory Affairs & Certification basic safety and health requirements of the Documentation supervisor: EU Directives, both in its basic design and S.
Technical specifications Type HD 6/12-4C HD 6/15 C 1.150-900.0 1.150-907.0 1.150-901.0 HD 6/12-4 CX HD 6/15 CX 1.150-902.0 1.150-916.0 Main Supply Voltage Current type 1~ 50 1~ 60 Connected load Protection (slow, char. C) Type of protection IPX5 Maximum allowed net impedance 0.386+j0.241 0.302+j0.189...
Page 13
Type HD 6/15 C HD 6/15 C 1.150-903.0 1.150-904.0 1.150-905.0 HD 6/15 CX HD 6/15 CX 1.150-914.0 1.550-915.0 Voltage Current type 1~ 50 Connected load Protection (slow, char. C) Type of protection IPX5 Maximum allowed net impedance 0.302+j0.189 Extension cord 30 m Water connection Max.
Page 14
Type HD 6/15 C HD 6/15 C HD 6/15 C 1.150-906.0 1.150-911.0 1.150-910.0 GB/AU Main Supply Voltage Current type 1~ 50 Connected load Protection (slow, char. C) Type of protection IPX5 Maximum allowed net impedance 0.302+j0.189 Extension cord 30 m Water connection Max.
Page 15
Type HD 7/10 HD 7/18 C HD 7/18 C 1.151-900.0 1.151-901.0 1.151-906.0 1.151-902.0 HD 7/18 CX HD 7/18 CX 1.151-908.0 1.151-907.0 EU II Main Supply Voltage Current type 3~ 50 Connected load Protection (slow, char. C) Type of protection IPX5 Maximum allowed net impedance Extension cord 30 m Water connection...