Data Regarding Noise Emission Values; Danger From Toxic Gases And Vapors; Danger From Flying Sparks - Fronius TransTig 170 Operating Instructions Manual

Data regarding The device produces a maximum noise level of <80 dB(A) (ref. 1pW) when idling and in
Noise Emission
the cooling phase following operation in relation to the maximum permitted operating point
Values
at standard loading in accordance with EN 60974-1.
A workplace-specific emission value for welding (and cutting) cannot be specified because
this value depends on the welding process and the environmental conditions. It is influ-
enced by a wide range of parameters, such as the welding process itself (MIG/MAG, TIG
welding), the selected current type (direct current, alternating current), the power range,
the type of weld metal, the resonance properties of the workpiece, the workplace environ-
ment, and many other factors.
Danger from toxic The fumes produced during welding contain toxic gases and vapors.
gases and vapors
Welding fumes contain substances that cause cancer, as stated in monograph 118 from
the International Agency for Research on Cancer.
Use at-source extraction source and a room extraction system.
If possible, use a welding torch with an integrated extraction device.
Keep your head out of the welding fumes and gases.
Take the following precautionary measures for fumes and harmful gases:
-
-
Ensure that there is a sufficient supply of fresh air. Ensure that there is a ventilation flow
rate of at least 20 m³ per hour.
Use a welding helmet with air supply if there is insufficient ventilation.
If there is uncertainty as to whether the extraction capacity is sufficient, compare the mea-
sured toxic emission values against the permissible limit values.
The following components are factors that determine how toxic the welding fumes are:
-
-
-
-
-
Consult the corresponding material safety data sheets and manufacturer's instructions for
the components listed above.
Recommendations for exposure scenarios, risk management measures and identifying
working conditions can be found on the European Welding Association website under
Health & Safety (https://european-welding.org).
Keep flammable vapors (such as solvent vapors) out of the arc radiation range.
When no welding is taking place, close the valve of the shielding gas cylinder or the main
gas supply.
Danger from Fly-
Flying sparks can cause fires and explosions.
ing Sparks
Never undertake welding near flammable materials.
Flammable materials must be kept at least 11 meters (36 ft. 1.07 in.) from the arc or pro-
tected with a certified cover.
Keep suitable, tested fire extinguishers on hand.
10
Do not breathe them in.
Extract them from the work area using appropriate equipment.
The metals used for the workpiece
Electrodes
Coatings
Cleaning agents, degreasers, and the like
The welding process used