Fall Hazards; Collision Hazards - Mec 45-AJ Diesel Operator's Manual

45-AJ Diesel 45-AJ Diesel 45-AJ Diesel

Fall Hazards

DO NOT CLIMB ON RAILS
DO NOT ENTER OR EXIT PLATFORM
WHEN ELEVATED

Collision Hazards

Page 6
DO NOT sit, stand or climb on the platform guard rails. Maintain a firm footing on the
platform floor at all times.
Keep the platform floor clear of debris.
DO NOT fasten a fall restraint lanyard to an adjacent structure.
Ensure that all gates are properly closed and secured before operating the machine.
Operators must comply with employer and job site rules and governmental regulations
regarding the use of Personal Fall Protective Equipment.
DO NOT exit the platform when elevated
ALWAYS check over, under and around the machine for personnel, structures and
obstructions before activating any control function and continue to watch for hazards while
operating the machine.
Check path before moving for equipment, materials or other obstructions.
Check for overhead obstructions before moving.
DO NOT place the boom or platform against another structure.
Check path before moving for crushing hazards when holding the platform rail.
Reduce travel speed when moving the machine on slopes, when near personnel and obstacles,
or when surface conditions are wet, slippery or otherwise limiting.
DO NOT operate in the path of any crane unless the controls of the crane have been locked out
and/or precautions have been taken to prevent any possible collision.
Stunt driving and horseplay are PROHIBITED.
Check for personnel and obstructions below the platform when lowering the platform.
Introduction 45 Safety
Safety 60-J Diesel Safety
94533r1 - December 2017