Table of Contents
Advertisement
THE PELLET CONTROL PANEL REPLACEMENT
1. Disassemble the bolts on the hopper bottom panel.
2. Cut off the cable tie for internal wires.
3. Disconnect all the wire couplings of fan motor, auger drive motor, hot rod and power cord
(Detail wire pairing is as shown in P.28 DIGTAL THERMOSTAT CONTROL WIRING
DIAGRAM).
4. Disassemble the bolts on the pellet control panel then take out the control panel from the
bracket.
5. Hold up the pellet control panel and disassemble the bolts for fixing the terminals of
temperature detector (RTD sensor) then you can remove the terminals of temperature
detector.
6. Replace a new pellet control panel. Connect all the wire couplings to the related position
(refer P.28 DIGTAL THERMOSTAT CONTROL WIRING DIAGRAM). Tie up the wires with
cable tip then assemble all the parts with their original bolts.
27 of 30
20191010-Ver.1.0
Advertisement
Table of Contents
