34
Connecting the Battery
5. Insert the twisted B, A G wires and the battery's Enable wire into pin holes 4-7, as
shown below.
Figure 16: Communication cable connection - LG Chem battery to inverter
6. Tighten the screws and make sure the wires cannot be pulled out easily.
7. Make sure the RS485-2 DIP switch (the right switch) is OFF.
8. Connect DC cables between the inverter and battery.
WARNING!
Make sure to connect the power cables at correct polarity. Connecting the
power cables at reverse polarity may result in damage to the inverter or
battery.
Figure 17: DC cable connection - LG Chem battery to inverter
9. Close the inverter and Connection Unit covers with the Allen screws.
StorEdge Single Phase Inverter with HD-Wave Technology MAN-01-00627-1.1