Usb Charging - VOLTCRAFT IPC4 Operating Instructions Manual

Selecting cycles
5
Once the "Cycle" programme has been selected, you can adjust the discharge-charge cycles as needed.
By default, 3 cycles are preset by the charger. If this value is to be changed, select the "Cycles" subitem
and confirm the selection using the middle button.
You can now select the desired number of cycles using the arrow buttons and then confirm the selection
using the middle button.
Starting the process
6
After all parameters have been set according to your wishes, you can start the programme using the
"► Start process" menu item.
Use the arrow buttons to select this menu item and then use the middle button to confirm the selection.
The programme will start.
If no selection is made within approx. 15 seconds, the programme will start automatically.

11. USB charging

You can use the rear USB-A output (5) to charge any device that is normally charged via a USB charging
cable. The maximum output current of the USB port is 2.1 A.
Please note that using the USB output during charging will automatically reduce the
performance of the charging slots.
41