G) Inductive Charging (Wireless) And Charging Via Usb; H) Measuring The Speed Of A Motor With Controller - VOLTCRAFT V-CHARGE 600 DUO Operating Instructions Manual

'Discharger' with discharge device operating mode
4
To use the 'Discharger' operating mode, connect a discharge device to the EXT.DISC discharge connection (7) and
set the operating mode to 'Discharger'.
Use an external discharge device such as the UP-D200 Smart Discharger 200 W with the EXT.DISC connection (7).
You can now discharge with improved speed, achieving a discharging power of up to 200 W.
You must connect a discharge device when using the 'Discharger' operating mode.
Balancer mode – measure internal cell resistance
5
In balancer mode, the charger monitors the internal cell resistance of every cell in the battery pack. The internal
cell resistance can be used to determine the functionality and conservation status of a battery pack. The more even
the cell resistance of individual cells, the more functional/healthy the battery back. The resulting charging process
is dynamic, whereby the charging current or cell resistances adjust/fluctuate according to changing circumstances.
Recovering deeply discharged lithium batteries
6
The charger detects cell voltages, if they are too small, in order to start normal charging. It starts recovery of the
battery pack by charging with a very low charging current of 0.1 A. As soon as a voltage is reached that allows rapid
charging, charging is continued with a higher charging current.

g) Inductive charging (wireless) and charging via USB

• Lay your mobile device on the charging pad (8) with its rear facing down. Position it on the centre of the anti-slip
strip (4) to charge it. Charging starts when the charger is connected to the power supply.
• To charge a battery via USB, connect the USB cable to the USB port (2). Charging starts when the charger is
connected to the power supply.
You can use these two charging functions while using another charger function at the same time.

h) Measuring the speed of a motor with controller

• Use the Motor connection (5) to connect a motor to test its speed under
different conditions.
• Press and hold the rotary switch for the charging channel 2 (10) for approx.
2 seconds to open the test menu for motor speed.
• The motor starts to run. The motor speed is shown on the LCD display (9).
If necessary, change the speed setting on the motor controller and read off
the change.
29