Table of Contents
Advertisement
Pos : 3.1 /Ü bers chriften/Ü bersc hriften 1/A- E/Einl eitung @ 3\mod_1205494295858_6.doc x @ 73778 @ 1 @ 1
2
Introduction
Pos : 3.2 /Bei pac ks/Sons tige/D elta-Ter minal/Benutz erhi nweis e D elta-Ter minal @ 135\mod_1351517318554_6.doc x @ 1201042 @ @ 1
Operating errors on the terminal can only be avoided and trouble-free operation can only be
ensured when you know the content of these instructions.
These operating instructions must be read and observed before assembly and start-up of the
terminal to prevent problems during operation. Maschinenfabrik KRONE shall not be held
liable for any damage resulting from non-compliance!
Pos : 3.3 /Bei pac ks/Sons tige/D elta-Ter minal/Ü ber VT 50 @ 135\mod_1351517476175_6.doc x @ 1201070 @ 2 @ 1
Pos : 3.4 /Ü bers chriften/Ü bersc hriften 1/P-T /Sic her heit @ 0\mod_1195566748646_6.doc x @ 628 @ 1 @ 1
3
Safety
Pos : 3.5 /BA/Info-Center/CCI-ISOBUS-T ermi nal/Module für Beipac k/Hi nweise zur D arstellung_neu @ 46\mod_1281504687968_6.doc x @ 444505 @ @ 1
These operating instructions contain basic instructions to be considered during installation,
configuration, operation and maintenance. Thus it is absolutely essential to read these
instructions before configuration and operation.
Follow both the general safety instructions mentioned in chapter entitled "Safety" and the
specific safety instructions contained in the other chapters.
Pos : 3.6 /Ü bers chriften/Ü bersc hriften 2/K- O/Kennzeic hnung von Hinweisen i n der Anleitung @ 131\mod_1347536035233_6.doc x @ 1162496 @ 2 @ 1
3.1
Identification of instructions
Pos : 3.7 /BA/Sic her heit/Kennzeic hnung der Gefahrenhinweise_CCI_T ermi nal @ 46\mod_1281504857828_6.doc x @ 444531 @ @ 1
Warning - General hazards!
This occupational safety icon identifies general safety instructions. They represent danger for
life and limb of persons when they are ignored. Carefully observe the instructions regarding
occupational safety and exert particular caution in these cases.
Caution!
The caution icon identifies all safety instructions which refer to regulations, guidelines or
workflows. They must be strictly observed. The non-observance can cause damage or
destruction of terminal as well as malfunction.
Instruction
The instruction icon highlights application hints and other especially useful information.
Pos : 3.8 /Ü bers chriften/Ü bersc hriften 2/A- E/Bes ti mmungsgemäße Verwendung @ 103\mod_1332169199326_6.doc x @ 940065 @ 2 @ 1
Ver
3.2
Intended use
Pos : 3.9 /BA/Info-Center/CCI-ISOBUS-T ermi nal/Module für Beipac k/Besti mmungsgemäßer Gebr auch @ 43\mod_1273648746453_6.doc x @ 383581 @ @ 1
The terminal is exclusively intended for use in agriculture. Any other installation or use of the
system is not included within the manufacturer's area of responsibility.
The manufacturer accepts no liability for any resulting personal injury or material damage. The
operator himself bears all risks for usage other than specified.
The intended use also includes the adherence to operating conditions and repair conditions set
by the manufacturer.
The relevant accident prevention regulations as well as any other generally accepted rules
relevant to safety, industry, medicine and traffic must be adhered to. Unauthorized modifications
to the device exclude the manufacturer's liability.
Pos : 3.10 /Übersc hriften/Übersc hriften 2/P-T/Sicher heitshi nweis e @ 110\mod_1336111632896_6.doc x @ 980495 @ 2 @ 1
3.3
Safety instructions
Pos : 3.11 /BA/Info-C enter/CC I-ISOBU S-Ter mi nal/M odul e für Bei pac k/Sicherheits vor kehr ung @ 43\mod_1273649362531_6.doc x @ 383605 @ @ 1
•
Do not remove any safety mechanisms or signs
•
Disconnect the power supply to the terminal during maintenance work or when using a
charging device on the battery of the towing/production machine
•
Never perform maintenance work or repairs when the device is switched on
•
Before performing any welding work on tractor or attached machine, disconnect the
power supply to the terminal
•
To clean the terminal, only use a soft cloth moistened with clean water or a bit of glass
cleaner
•
Use your fingertip to operate the keys. Do not use your fingernails
Introduction
3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Terminal Beta II and is the answer not in the manual?
Questions and answers