John Lewis Ashton High Sleeper Bed Assembly Instructions Manual page 6

Step 5
Attach the ladder to Side Rail Front (11) using Bolt M6x 35mm (H) and tighten it using Allen
Key M4 (A) as shown below.
WARNING
Maximum height of
the mattress. DO NOT
EXCEED THIS LINE.
Please note: The grooved lines indicate the point which the mattress should not exceed, the
maximum height of the mattress to be used is 19cm.
Recommended size mattress is L:190cm, W: 90cm, H:19cm (max)
Step 6
PLEASE NOTE: The slats at each end have been cut to allow them to fit so that there are NO GAPS.
Starting at one end of the bed, secure the first fitted slat into place using Screw (K). Next secure the fitted
slat to the other end and secure using Screw (K) ensuring that there are NO GAPS between the slats and
the Headboards. Finally secure the rest of the Slats into place using Screw (K) as shown in the diagram
below using a Phillips Head Screwdriver.
Note: Ladder can be placed
either end of High Sleeper.