Summary of Contents for John Lewis St Ives Bed 810/81001
Page 1
Please check the pack contents before attempting to assemble this product. A full checklist of components is given in this leaflet. If any components are missing, please contact the John Lewis Helpline. This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE WHEN LIFTING to avoid personal injury and (or) damage to the product.
Page 2
Fittings and parts checklist Fittings 4mm Allen Key x1pc 15mm Screws x8pcs M8 x 22mm Bolt x8pcs Slat Connectors x14pcs Cap Ends x28pcs Centre Rail Cup x2pcs Parts Headboard x 1 Footboard x 1 Side Rail x 2 Centre Rail x 1 Slats x 28...
Page 3
Step by step assembly instructions Step One Attach the Centre Rail Cup (C) to the lower rail of the Headboard (1) and Footboard (2) using 15mm Screws (D) as shown in the diagram below. &...
Page 4
Step Two Attach the Side Rails (3) to the Headboard (1) and Footboard (2) using M8 x 22mm Bolts (B) as shown below. Tighten the Bolts (B) using the 4mm Allen Key (A) provided. 1 1 1 &...
Page 5
Step Three Lower the Centre Rail (4) onto the Centre Rail Cups (C) on the Headboard (1) and Footboard (2) as shown in the diagram below. &...
Page 6
Step Four With the curved side facing upwards, insert 2 Slats (5) into a Slat Connector (E) followed by a Cap End (F) onto the other end of both slats. Use your palms to push down the centre cap into the centre rail followed by the cap ends into the side rail as shown in the diagram below.
Please be careful to retain all fittings when doing this. If you require any additional information or have any issues with this product please call the John Lewis helpline on 01244 689949 or email mail@fwgroup-uk.com John Lewis Partnership 171 Victoria Street London SW1E 5NN www.johnlewis.com...