Table of Contents
Advertisement
● If you select R NDCS ，" 017N" will appear on LCD ， now you can use
[UP]/[DOWN] key to select normal DCS code ， then press [F] key to
confirm your selection and enter transmitting with CTCSS/DCS setting
mode.
● If you select R IDCS ，" 017I" will appear on LCD ， now you can use
[UP]/[DOWN] key to select invert DCS code, then press [F] key to
confirm your selection and enter transmitting with CTCSS/DCS setting
mode.
4.After finishing setting receiving with CTCSS/DCS，you can set
transmitting with CTCSS/DCS, "
Set Transmitting with CTCSS/DCS
The operation of setting transmitting with CTCSS/DCS is the
same as receiving, except "
" will appear on LCD.
T OFF
" instead of "
" on LCD.
T
R
Note:
●" CT" will appear on LCD when CTCSS function is activated.
" DCS" will appear on LCD when DCS function is activated.
Both "CT" & "DCS" will appear on LCD when CTCSS & DCS function is
activated.
● All operation should be done in 10 seconds, otherwise, the transceiver
will return to current working mode, you have to re-operate from the
beginning.
Standard CTCSS Tones Table
1 – 63.0
14 - 100.0
2 - 67.0
15 - 103.5
3 - 69.3
16 - 107.2
4 - 71.9
17 - 110.9
5 - 74.4
18 - 114.8
6 - 77.0
19 - 118.8
7 - 79.7
20 - 123.0
8 - 82.5
21 - 127.3
9 - 85.4
22 - 131.8
10 - 88.5
23 - 136.5
11 - 91.5
24 - 141.3
12 - 94.8
25 - 146.2
13 - 97.4
26 - 151.4
27 - 156.7
40 - 196.6
28 - 159.8
41 - 199.5
29 - 162.2
42 - 203.5
30 - 165.5
43 - 206.5
31 - 167.9
44 - 210.7
32 - 171.3
45 - 218.1
33 - 173.8
46 - 225.7
34 - 177.3
47 - 229.1
35 - 179.9
48 - 233.6
36 - 183.5
49 - 241.8
37 - 186.2
50 - 250.3
38 - 189.9
51 - 254.1
39 - 192.8
Advertisement
Table of Contents
