ADI AQ-16 Manual page 17

which you would like to call. You can access Menu No. 19 to
select this function ON/OFF(default).
20. Push-To-Talk ID (PTT ID)
PTT ID is a generic term for an ANI-like system used in Two-way
radio systems. It provides identification of the transmitting radio
over the air, and is commonly used in Selective calling/signaling
systems. You can access Menu No. 20 to select this function
ON/OFF(default).
21. Set-up Name of Memory Channel (NAME)
You can name memory channels using up to 6 alphanumeric
characters. When you recall a named memory channel, its name
appears on the LCD instead of the channel number. Please
access Menu No. 21 to name memory channels.
22. Select the default function of [PKEY] key (KEYSET)
You can access Menu No. 22 to select the default function of
[PKEY] key (default: MONI).
1).MONI
In VFO/MR/CH mode, press [PKEY] key to monitor the channels;
release to no monitor.
2).CALL
In VFO/MR/CH mode, when switch DTMF function on, press
[PKEY] key, then plus other key (anyone from 0-9) to transmit the
DTMF code.
3).EMG
In VFO/MR/CH mode, press [PKEY] key to transmit emergency
alert; if you want to stop transmitting, press [PTT] key.
4).1750Hz
In VFO/MR/CH mode, press and hold [PKEY] key to transmit
1750Hz signal; release to stop transmitting.
Note:
You can also set the default function of [PKEY] key with programming
software to be one of the above 4 items.
23. Send your ID to Receiver (SET ID)
"SET ID" is the function for sending your ID to receiver. Before