Menu Operation; Menu Access - ADI AQ-16 Manual

the transceiver.
2.To prevent interference, listen on the channel before
transmitting by pressing and holding [PKEY] key (Default:
Monitor).
3.When ready to begin transmitting, press and hold [PTT] switch
and speak in a normal voice level.
● The TX/RX indicator on the top panel lights red and S/RF meter shows
the output power level.
● Speaking too close to the microphone, or too loudly, may increase
distortion and reduce intelligibility of your signal at the receiving
transceiver.
4.When you finish speaking, release [PTT] switch to receive.
Note:
If you transmit continuously for more than 3 minutes (Default setting of
TOT), the internal time-out timer generates a warning beep and the
transceiver stops transmitting. In this case, release [PTT] switch and let
the transceiver cool down for a while, then press [PTT] switch again to
resume transmitting.

MENU OPERATION

Menu Access

1.In VFO/MR/CH mode, press [MENU] key to enter Menu mode.
● The menu appears.
2.Use the [UP]/[DOWN] key to select the desired Menu Number.
3.Press [F] key to confirm the selection
4.Then use the [UP]/[DOWN] key to switch ON/OFF or select
numeric values.
5.Press [F] key again to complete the setting.
6.Press any key other than [PKEY],[LAMP], [UP]/[DOWN] and [F]
key to exit menu mode.
Note:
In this manual, when you enter and use menu system to select, or want to
activate the second function when press [F] key with other keys, Please
make sure the operation in 10 seconds after pressing [F] key. Otherwise,
the transceiver will turn back to original working mode.