Pump Off / Rest Setup - Graco G3 SP Series Instructions Manual

Quick Setup Guide
• The LED under the #
sign lights when setting
the number of cycles.
1. Program the number of
cycles by pressing the UP or
DOWN ARROW button to
move up or down through
number 0-9.
2. The cycle field is a 2 digit number. When
the correct first numeral of the number
displays, press the ENTER button to
save the number. The cursor automati-
cally moves to the second number field.
NOTE: A leading zero (0) must be entered in the
first field if the number of cycles is fewer than 10.
3. Press the ENTER button, to save the CY
information.
4. After you set the last field and press the
ENTER button, the G3 saves the Cycle
information and moves to setting OFF
Time, page 22.

PUMP OFF / REST Setup

After setting the Cycle (CY) parameters the OFF or
pump rest cycle must be set up.
• The LED next to the clock in the OFF
field lights, indicating you are setting
the OFF Time parameters.
• OFF Time is set in Hours and Minutes
(HH: MM) or Hour, Hour, Hour, Hour (HHHH) when
A8 is on.
• An LED flashes under
either HH when pro-
gramming hours OR
MM when program-
ming minutes.
22
OR
• In SETUP MODE the
number displayed in
the third and fourth
fields on the right side
of display blink, indi-
cating the device is
ready to program the OFF Time hours when A8 is
off. When A8 is on, the number displayed in the first
field on the left side of the display, blinks.
• The total amount of OFF Time must
be at least twice as long as the ON
Time. If a value less than twice the
ON Time is entered, the pump will
run three times and will fault out if the time is not
corrected before the third time.
If this time does not meet the application needs,
contact Graco Customer Support.
Programming OFF Time: A8 Off
NOTE: The maximum OFF time is 8 hours when A8 is
off.
1. OFF time is set in 15 minutes
increments. Use the UP or
DOWN ARROW button to set
the time.
2. Press the ENTER button to
save the OFF Time information.
Programming OFF Time: A8 On
NOTE: You must program leading zeros in the number
field and press the ENTER button to save the zero
selection; i.e, 400 hours = 0400.
1. To set the OFF Time use the
UP or DOWN ARROW button
to scroll through numerals 0
to 9 until the desired number
appears in the first HHHH
(hours) field.
2. Press the ENTER button to lock in the
selection. The next HHHH number field
to the right flashes indicating it is ready
for programming.
3A4676B