PureEdge Lighting Fast Jack Power Round & Square 4" FJP-4 Series Installation Instructions

Installation Instructions for Fast Jack Power Round & Square 4" Flat
Canopies

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.
- This product is dimmable with a standard ELV dimmer.
- The product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches (98
cubic centimeters).
SAVE THESE INSTRUCTIONS!
Install the Canopy
A
ELECTRICAL
BOX
2
TRANSFORMER
5: Connect each Fast Jack assembly wire to one low voltage
transformer wire with a wire nut.
1: Turn the power to the electrical box off.
2: Connect the white transformer wire to the neutral power
wire with a wire nut.
4
3: Connect the black transformer wire to the hot power wire
with a wire nut.
4: Place the transformer and transformer wires inside the
3
electrical box.
B
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: 773.935.5613
www.PureEdgeLighting.com ● info@PureEdgeLighting.com
© 2016 PureEdge Lighting. All Rights Reserved.
5
FAST JACK
ASSEMBLY
Doc # 904-FJP-4RD_03
FJP-4_-_
5
1