Water Supply Connection - Fisher & Paykel ACTIVESMART RS80 Installation Manual

IMPORTANT!
Water fittings kit
(Ice and Water
The water connection instructions below are intended only for
●
models only)
the professional installer.
The appliance comes with a pre-connected plastic water tubing.
●
Water fittings are not supplied and must be purchased separately.
●
Ensure the appliance is connected to its own isolating switch.
●
Water tap adaptor
(1)
Connect to water supply (Ice and Water models only)
Move the appliance in front of the cabinetry close enough that you still have
1
access behind for power and water connections (A).
Collet locking clip
(1)
!3

WATER SUPPLY CONNECTION

A
Ensure there is enough tubing for the water connection and to pull
●
the appliance out for service, if required.
Flush water through the hose prior to connection to the appliance
●
to remove any debris in the hose.
Insert (B) the free end of the plastic water tubing fully into a water tap
2
adaptor and pull (C) gently to ensure it is locked in.
Secure connection by inserting a locking key (D) between the water tap
3
adaptor and locking collet.
Connect the water tap adaptor to a water tap (E).
4
– Flush water through the hose prior to connection to the appliance
to remove any debris in the hose.
Turn on the water tap and check all connection are dry and free of drips.
5
E
D
B
C
19