Fisher & Paykel ACTIVESMART RS80 Installation Manual page 28

Tools Attach the door panels
Open the door and loosen the M5x10 cross-head
1
screws (do not remove) at the sides of the doors (A).
Hang the door panel by inserting the M8 studs
2
through the holes of the hanging bracket (B).
Cross-head screwdriver
Slide the forks of the side brackets onto the
3
screws of the door (C).
Screw the M8 washer and nut to each stud
4
(D), and re-tighten the side screws (E) using
the hex key and spanner to fix the door
panel (do not fully tighten). This will allow
opening the door without affecting
adjustment of the door panel.
Powered driver (optional)
Hex key
FPA spanner
26
!8 DOOR PANEL INSTALLATION — STAINLESS STEEL
E
A
C
B
D