Fisher & Paykel ACTIVESMART RS80 Installation Manual page 35

IMPORTANT!
Door panel
B
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
●
attachment
kit
Adjust the door panels
8x16 mush washer screw
(1) Push the appliance into the cavity until the door panels are flush
1
with adjacent cabinetry.
Place a ruler on the front of the appliance to check flushness top
Tools 2
and bottom, left and right.
Hex key
#8 x 16
Mush Washer
Twin Thread
Philips Screw
FPA spanner
Cross-head screwdriver
Powered driver (optional)
Ruler
!9 DOOR PANEL INSTALLATION — CUSTOM
2
3
4
5
A
Each door panel has full axis adjustment to ensure flushness
with adjacent walls. To adjust the height of the panel, turn the
stud clockwise to raise or counter-clockwise to lower the door
panel (A).
Once satisfied with the alignment, secure M8 studs with M8
washer and M8 nut (B). The top of the stud must remain below
the top face of the door panel.
Secure side bracket forks by tightening
side screws (C).
Repeat for all door panels.
Note:
– For depth adjustment, loosen the
side screws, adjust the panels and
then retighten once satisfied.
– Further adjustment of door panels
can be achieved by removing door
panels then loosening the fixing
screws for the hanging bracket and
moving the bracket sideways to suit.
Loosen the M8 stud (D) so that locking
bracket can slide freely back to front.
– Slide the locking bracket out until it
touches the back of the door panel.
Fully tighten the M8 stud.
– Screw in place using a #8x16 screw
through one of the three slotted
holes.
B
C
D
33